Figure 1-5 Typical Manual Entry Lan Network Interface - Keysight N1911A Installation Manual

1 Getting Started
Static mode (configuring the LAN manually)
In static mode you must set up the IP address, subnet mask, and default gateway
that is compatible with your network infrastructure. If it is not correctly setup, the
power meter is not be visible on your network.
If you configure an invalid IP address or an IP address that is used by another
NOTE
device or host, an error message is generated. This error can be read by pressing
1 Switch the power on to the power meter.
2 Press
3 Press
Figure 1-5
4 Press
5 Press
30
, Error List or by using the SYSTem:ERRor? command.
,
Remote Interfaces
Figure 1-3).
Network Manual
Gateway value is an optional setting.
To individually specify the settings use the arrow keys, Select key, and use the
numeric keys followed by
mask, and default gateway.
The values can range between 0.0.0.0 and 255.255.255.255.
Typical manual entry LAN network interface
, to return to the Remote Interface display.
Restart Network
to display the Remote Interface display (see
to set the IP Address, Subnet Mask. The Default
keys to enter the required IP address, subnet
Enter
.
Keysight N1911A and N1912A Installation Guide