Figure 1-1 Example Of Initial Connection Windows - Keysight N1911A Installation Manual

1 Getting Started
Before connecting the USB cable, make sure that I/O software is installed on
NOTE
your computer.
See
Keysight IO Libraries software. If you have installed other I/O software, refer to
documentation that accompanies the software.
1 After I/O software is installed on your computer, connect your P-Series power
2 The PC confirms the hardware connection as shown in
Figure 1-1
3 The Found New Hardware Wizard automatically starts and guides you through
If you installed Keysight IO Libraries software, you also installed low-level
NOTE
drivers. Therefore, you do not need to insert the CD when Found New Hardware
Wizards requests you to do so.
24
"Remote Interface Configurations"
meter to your PC using the supplied Type A - Mini 5 pin USB cable.
Example of initial connection Windows
configuring the power meter as a USB device. Click
automatically, accept all defaults to complete the installation.
on page 23 for information about the
Keysight N1911A and N1912A Installation Guide
Figure 1-1.
to install the software
Next