Table of Contents
Advertisement
Setup
3. Setup
AC Power
Each Ovation E-910FC IP has an auto-ranging power supply that works with an input voltage range of 100
to 240 VAC, 50/60 Hz. To determine the power requirements for each Ovation E-910FC IP, refer to the
label affixed to the product or to the Technical Specifications chart in this manual.
The listed current rating indicates the maximum current draw during normal operation. For more
information, download Sizing Circuit Breakers from the Chauvet website: www.chauvetprofessional.com.
•
Always connect the product to a protected circuit (a circuit breaker or fuse). Make sure
the product has an appropriate electrical ground to avoid the risk of electrocution or
fire.
•
To eliminate unnecessary wear and improve its lifespan, during periods of non-use
completely disconnect the product from power via breaker or by unplugging it.
Never connect the product to a rheostat (variable resistor) or dimmer circuit, even if the
rheostat or dimmer channel serves only as a 0 to 100% switch.
AC Plug
The Ovation E-910FC IP comes with a power input cord terminated with a Seetronic Powerkon A connector
on one end and an Edison plug on the other end (U.S. market). If the power input cord that came with the
product has no plug, or if the plug needs to be changed, use the table below to wire the new plug.
Connection
AC Live
AC Neutral
AC Ground
Power Linking
It is possible to power link Ovation E-910FC IP products. See the table below for the current draw at each
voltage and frequency:
100 V, 60 Hz
Current Draw
2.2 A
Never exceed 12A on a single circuit. Power-linking cables can be purchased separately..
•
Use Seetronic Powerkon cables to preserve the IP65 rating and the warranty of this
product.
•
Insert the attached IP65-rated plugs into the corresponding power/data connections
when not in use.
Fuse Replacement
1. Disconnect this product from the power outlet.
2. Using a Phillips-head screwdriver, unscrew the fuse holder cap from the housing.
3. Remove the blown fuse and replace with another fuse of the same type and rating (T 3.15 A, 250 V).
4. Screw the fuse holder cap back in place and reconnect power.
Make sure to disconnect the product's power cord before replacing a blown fuse. Always
replace the blown fuse with another of the same type and rating.
Ovation E-910FC IP User Manual Rev. 11
Wire (U.S.)
Black
White
Green/Yellow
120 V, 60 Hz
208 V, 60 Hz
1.8 A
Wire (Europe)
Brown
Blue
Green/Yellow
230 V, 50 Hz
1.03A
.966 A
Screw Color
Yellow or Brass
Silver
Green
240 V, 60 Hz
.935 A
7
Advertisement
Table of Contents
