Grizzly G1014Z Owner's Manual page 26

12. Loosen the two set screws on the work table
arm so their ends are flush with the inside of
the opening, as shown in Figure 28.
Opening
Work
Table
Arm
Table Mount
Bracket Screw
Figure 28. Location of set screws on work table
arm.
13. Loosen the angle adjustment knob on the
work table (Figure 28), tilt the table to the 0º
mark, then tighten the knob.
14. Slide the work table arm onto the table sup-
port rod, making sure that the set screws on
the table arm face the flat part of the rod, as
shown in Figure 29.
Figure 29. Installing work table onto table
support rod.
-24-
15. Using a ruler (see Figure 29) adjust the edge
Set
Screws
Angle
Adjustment
Knob
Figure 30. Correct distance between disc and
To reduce the risk of your fingers getting
stuck between the work table and sanding
disc, set the table approximately
from the sanding disc.
16. Square the table to the sanding disc (refer to
17. Adjust the miter gauge slot parallel with the
of the work table approximately
from the sanding disc on both sides (see
Figure 30), then tighten the set screws on the
work table arm.
⁄ "
1
16
Gap
work table.
—If the gap between the work table and the
sanding disc is not the same on both sides,
loosen one of the table mount bracket
screws (see Figure 28), adjust the table
as needed to even the gap, then tighten
the screw.
instructions on Page 50 for more details).
sanding disc (refer to instructions on Page
51 for more details), then insert the miter
gauge.
Model G1014Z/G1014ZX (Mfd. Since 07/17)
1 ⁄ " away
16
⁄ " away
1
16