Grizzly G1014Z Owner's Manual page 25

7.
While looking through the access hole on the
side of the cover, rotate the plate and tighten
each of the set screws to secure the plate to
the drive shaft (see Figure 24).
Set Screws
Figure 24. Securing plate to drive shaft.
8.
Peel off the backing on the 9" PSA (pres-
sure sensitive adhesive) sanding disc, make
sure the cast iron plate is clean, and install
the sanding disc onto the plate, as shown
in Figure 25. Make sure the sanding disc
adheres completely flat against the plate.
Figure 25. Installing sanding disc onto cast iron
plate.
Model G1014Z/G1014ZX (Mfd. Since 07/17)
Access Hole
9.
Install the 2 ⁄ " black plastic dust port onto the
1
2
pulley cover with the (4) #10-24 Phillips head
screws, #10-24 hex nuts and #10 flat wash-
ers, as shown in Figure 26.
Pulley
Cover
Figure 26. 2 ⁄ " dust port installed.
1
2
10. Secure the pulley cover with the thumb knob.
11. Loosen the two set screws on the back of
the base, slide the table support rod into the
shaft, making sure the flat of the shaft faces
the set screws, then tighten the set screws,
as shown in Figure 27. The rod should pro-
trude about 6 ⁄ " from the side of the base.
1
4
Figure 27. Installing table support rod.
x4
Dust Port
Table
Support
Rod
6 ⁄ "
1
4
-23-