Grizzly G1014Z Owner's Manual page 41

—If the distance is not the same from side-
to-side, loosen the screws that secure the
work table arm to the work table. Then
adjust the table until the miter slot-belt
distance is even side-to-side and the table
is approximately
across its entire length.
13. Insert the miter gauge into the left side of the
miter slot.
Performing Vertical Sanding
1. Adjust the angles of the work table and miter
gauge for your operation.
2.
Place the workpiece on the table and firmly
against the miter gauge.
3.
Slowly and with light pressure, move the
workpiece into the left side of the sanding
belt. See Figures 66–69 for examples of
horizontal belt sanding.
Figure 66. Example of end grain sanding.
Model G1014Z/G1014ZX (Mfd. Since 07/17)
⁄ " away from the belt
1
16
Figure 67. Example of vertical miter sanding.
Figure 68. Example of vertical face and edge
sanding.
Figure 69. Example of sanding round workpiece
in vertical position.
-39-