Grizzly G1014Z Owner's Manual page 22

5.
Fasten the two short upper braces and the
two short lower braces to one of the leg
assemblies with the (8)
bolts, ⁄ "-18 hex nuts, and
5
16
as shown in Figure 12.
Short Lower
Brace
Short
Upper
Braces
Figure 12. Short upper and lower braces
fastened to leg assembly.
Make sure the two short upper braces over-
lap the long upper braces and that the braces
are placed inside the leg assemblies, as
shown in Figure 13.
Short Upper Brace
Long Upper Brace
Figure 13. Short brace overlapping long upper
brace.
6. Fasten the second leg assembly to the brac-
es on the first leg assembly with the remain-
ing (8) ⁄ "-18 x ⁄ " carriage bolts,
5 1
16 2
nuts, and ⁄ " flat washers, then place the
5
16
stand upright on its feet, as shown in Figure
14.
-20-
⁄ "-18 x ⁄ " carriage
5 1
16 2
⁄ " flat washers,
5
16
x8
Area of Overlap
⁄ "-18 hex
5
16
Figure 14. Stand assembled.
7.
Final tighten all the fasteners on the stand.
8.
Tighten the lock nuts on the feet.
9.
(Optional) Place a level on top of the stand
(Figure 15) and adjust the stand if needed by
shimming the feet so it is level from front-to-
back and side-to-side.
Figure 15. Leveling stand.
Model G1014Z/G1014ZX (Mfd. Since 07/17)