Voltages (Menu); Cnc (Menu); Ita (Menu) - Comtech EF Data DMD-2050E Installation And Operation Manual

DMD2050E Universal Satellite Modem
4.4.4.2

VOLTAGES (menu)

VOLTAGES MENU
TEMPERATURE
+1.5V RX SUPPLY
+1.5V TX SUPPLY
+3.3V SUPPLY
+5V SUPPLY
+12V SUPPLY
+20V SUPPLY
-12V SUPPLY
4.4.4.3

CnC (menu)

IMPORTANT
When the Carrier-in-Carrier
CnC DELAY
CnC FREQ OFFST
CnC RATIO
RX BUFFER LEVEL
RX BUFFER RESET (ENTER)
4.4.4.4

ITA (menu)

IMPORTANT
When in EBEM Mode and the ITA option is enabled this menu available.
TX WAVEFORM
RX WAVEFORM
MN-DMD2050E Revision 2
Displays internal temperature.
Displays the measured voltage of the 1.5 Volt Rx power bus located inside the modem.
Displays the measured voltage of the 1.5 Volt Tx power bus located inside the modem.
Displays the measured voltage of the +3.3 Volt power bus located inside the modem.
Displays the measured voltage of the +5 Volt power bus located inside the modem.
Displays the measured voltage of the +12 Volt power bus located inside the modem.
Displays the measured voltage of the +20 Volt power bus located inside the modem.
Displays the measured voltage of the -12 Volt power bus located inside the modem.
Routine delay (ms)
Runtime Frequency Offset (KHz) between interferer and the correct
received signal.
Power Ratio between interferer and the correct signal in dB.
{0 – 100%} Displays the status of the Doppler Buffer.
Press ENTER to re-center the Doppler Buffer.
{UNAVAVILABE, Mod and CR}
See section 4.4.1.9
{UNAVAVILABE, Mod and CR}
See section 4.4.2.7
option is installed, these parameters are available.
®
Displays the current modulation and code rate
operating in the transmitter
Displays the current modulation and code rate
operating in the receiver
User Interfaces
4–27