Reset The Ethernet M&C Port; Re-Enter The Modem Ip Address - Comtech EF Data DMD-2050E Installation And Operation Manual

DMD2050E Universal Satellite Modem
D.6.4.2 Reset the Ethernet M&C port
To reset the Ethernet M&C port, either 1) cycle the electrical power OFF and ON, or, 2) re-enter
the Modem IP Address. Re-entering the Modem IP Address avoids traffic disruption.
D.6.4.3 Re-enter the Modem IP address
1. Go to SYSTEM / TCP/IP / MODEM IP ADDR.
2. Press ENTER.
3. Type the new IP Address and press ENTER.
4. Press ENTER again.
5. Retype the new IP Address and press ENTER.
IMPORTANT
You must change the IP Address. If you just press ENTER repeatedly without changing
the IP Address, the Ethernet M&C port is not reset.
MN-DMD2050E Revision 2
Web Browser Setup Guide
D–16