Setting Up; Usable Outlet; Installation Mode - Panasonic PT-RQ32K Operating Instructions Manual

Setting up

Usable outlet

This projector supports AC 100 V to AC 120 V, and AC 200 V to AC 240 V as the power supply. A grounded outlet
supporting 30 A is required when using the projector with AC 200 V to AC 240 V. A grounded outlet supporting
15 A is required when using the projector with AC 100 V to AC 120 V.
The shape of the usable outlet differs depending on the power supply. Following illustrations are examples.
2P/3W 30 A 250 V
NEMA L6-30
Attention
f Use the supplied power cord and ground at the outlet.
f Use the power cord matching the used power supply voltage and outlet shape.
Note
f The light output will decrease to approximately 1/3 when using the projector with AC 100 V to AC 120 V.
f The supplied power cords vary depending on the country or region where you purchased the product.

Installation mode

The installation modes of the projector are as follows. Set [FRONT/REAR]/[FLOOR/CEILING] in the
[PROJECTOR SETUP] menu → [PROJECTION METHOD] (x page 138) depending on the installation mode.
Setting on a desk/floor and projecting forward
Menu item
[FRONT/REAR]
[FLOOR/CEILING]
Mounting on the ceiling and projecting forward
Menu item
[FRONT/REAR]
[FLOOR/CEILING]
Chapter 2 Getting Started — Setting up
2P/3W 30 A 250 V
Clock position 6h
Setting on a desk/floor and projecting from rear
(Using the translucent screen)
Setting value
[FRONT]
[AUTO] or [FLOOR]
Mounting on the ceiling and projecting from rear
(Using the translucent screen)
Setting value
[FRONT]
[AUTO] or [CEILING]
2P/3W 15 A 125 V
Menu item
[FRONT/REAR]
[FLOOR/CEILING]
Menu item
[FRONT/REAR]
[FLOOR/CEILING]
Setting value
[REAR]
[AUTO] or [FLOOR]
Setting value
[REAR]
[AUTO] or [CEILING]
ENGLISH - 37