Panasonic PT-RQ32K Operating Instructions Manual page 141

4) Press the <ENTER> button.
f The [LENS INFORMATION SETTING] screen is displayed.
5) Press as to select [LENS NAME].
6) Press the <ENTER> button.
f The [LENS NAME INPUT] screen is displayed.
7) Press asqw to select the character, and press the <ENTER> button to enter the character.
8) Press asqw to select [OK], and press the <ENTER> button.
f Name of the projection lens is changed.
Note
f [LENS INFORMATION SETTING] is not displayed when a projection lens without built-in EEPROM is attached.
f Factory default name is [LENS01].
f If the standard DC motor unit installed in the Zoom Lens (Model No.: ET-D75LE6, ET-D75LE8, ET-D75LE10, ET-D75LE20, ET-D75LE30,
ET-D75LE40, etc.) is replaced with the stepping motor unit using the Stepping Motor Kit (Model No.: ET-D75MKS10), the [LENS NAME]
information is written into the EEPROM built in the stepping motor unit.
f [LENS NAME] will not return to factory default setting even when the [PROJECTOR SETUP] menu → [INITIALIZE] → [ALL USER DATA] is
executed.
[LENS MEMORY]
The adjusted lens position (vertical position, horizontal position, focus position, and zoom position) can be saved
and loaded.
Saving lens position
1) Press as to select [LENS].
2) Press the <ENTER> button.
f The [LENS] screen is displayed.
3) Press as to select [LENS MEMORY].
4) Press the <ENTER> button.
f The [LENS MEMORY] screen is displayed.
5) Press as to select [LENS MEMORY SAVE].
6) Press the <ENTER> button.
f The [LENS MEMORY SAVE] screen is displayed.
f If the lens memory has already been saved, the name of the saved lens memory and its lens position
information ([VERTICAL POSITION]/[HORIZONTAL POSITION]/[FOCUS POSITION]/[ZOOM POSITION])
are displayed in the [LENS MEMORY SAVE] screen.
7) Press as to select the item to save, and press the <ENTER> button.
f The confirmation screen is displayed.
f Current lens position information ([VERTICAL POSITION]/[HORIZONTAL POSITION]/[FOCUS POSITION]/
[ZOOM POSITION]) is displayed in the confirmation screen.
8) Press qw to select [OK], and press the <ENTER> button.
f The [LENS MEMORY NAME INPUT] screen is displayed.
9) Press asqw to select the text, and press the <ENTER> button to enter the text.
10) After the name is input, press asqw to select [OK], and press the <ENTER> button.
f Saving of the lens memory is completed, and the [LENS MEMORY SAVE] screen returns.
f If you press asqw to select [CANCEL] and then press the <ENTER> button, the lens memory will not be
saved.
f If you press asqw to select [DEFAULT] and press the <ENTER> button, the entered name will not be
registered and the default name will be used.
f If you select [OK] without entering any characters and press the <ENTER> button, the default name will be
used.
Chapter 4 Settings — [PROJECTOR SETUP] menu
ENGLISH - 141