Panasonic PT-RQ32K Operating Instructions Manual page 143

f The name of the saved lens memory and its lens position information ([VERTICAL POSITION]/
[HORIZONTAL POSITION]/[FOCUS POSITION]/[ZOOM POSITION]) are displayed in the [LENS MEMORY
DELETE] screen.
9) Press as to select the item to delete, and press the <ENTER> button.
f The confirmation screen is displayed.
10) Press qw to select [OK], and press the <ENTER> button.
Note
f The numeric value information of the zoom position is displayed only in following cases.
g When the standard DC motor unit installed in the Zoom Lens (Model No.: ET-D75LE6, ET-D75LE8, ET-D75LE10, ET-D75LE20,
ET-D75LE30, ET-D75LE40, etc.) is replaced with the stepping motor unit using the Stepping Motor Kit (Model No.: ET-D75MKS10)
g When the projection lens with stepping motor is attached
Changing the lens memory name
1) Press as to select [LENS].
2) Press the <ENTER> button.
f The [LENS] screen is displayed.
3) Press as to select [LENS MEMORY].
4) Press the <ENTER> button.
f The [LENS MEMORY] screen is displayed.
5) Press as to select [LENS MEMORY EDIT].
6) Press the <ENTER> button.
f The [LENS MEMORY EDIT] screen is displayed.
7) Press as to select [LENS MEMORY NAME CHANGE].
8) Press the <ENTER> button.
f The [LENS MEMORY NAME CHANGE] screen is displayed.
f The name of the saved lens memory and its lens position information ([VERTICAL POSITION]/
[HORIZONTAL POSITION]/[FOCUS POSITION]/[ZOOM POSITION]) are displayed in the [LENS MEMORY
NAME CHANGE] screen.
9) Press as to select the name to change, and press the <ENTER> button.
f The [LENS MEMORY NAME INPUT] screen is displayed.
10) Press asqw to select the text, and press the <ENTER> button to enter the text.
11) After the name is changed, press asqw to select [OK], and press the <ENTER> button.
f Saving of the lens memory is completed, and the [LENS MEMORY NAME CHANGE] screen returns.
f If you press asqw to select [CANCEL] and then press the <ENTER> button, the changed name will not
be registered.
f If you press asqw to select [DEFAULT] and press the <ENTER> button, the changed name will not be
registered and the default name will be used.
f If you select [OK] without entering any characters and press the <ENTER> button, the default name will be
used.
Note
f The numeric value information of the zoom position is displayed only in following cases.
g When the standard DC motor unit installed in the Zoom Lens (Model No.: ET-D75LE6, ET-D75LE8, ET-D75LE10, ET-D75LE20,
ET-D75LE30, ET-D75LE40, etc.) is replaced with the stepping motor unit using the Stepping Motor Kit (Model No.: ET-D75MKS10)
g When the projection lens with stepping motor is attached
[LENS HOME POSITION]
Operate in following procedure to move the projection lens to the home position.
1) Press as to select [LENS].
Chapter 4 Settings — [PROJECTOR SETUP] menu
ENGLISH - 143