Setting Up The Computer Wireless Card; Installing And Removing The Computer's Wireless Card - Panasonic PT-L502 Operating Instructions Manual

Setting up the computer wireless
card
When using an optional ET-CDWL1 series wireless card, it must be
installed to a computer and the driver software and Configuration Utility
must be installed into the computer.
This section describes the method of setting up the optional
ET-CDWL1 series wireless card.
If you have already set up your computer's wireless card, you
can skip to "Using the Wireless Manager" on page 36.
Setup procedure
Carry out the following steps in the order given to set up the computer's
wireless card.
Install the
card.
(Page 27)
Installing and removing the computer's
wireless card
Installing the wireless card
Hold the wireless card so that the power monitor is facing upward, and
insert it into the computer's PC card slot as far as it will go. Make sure that
the card is facing the right way.
Note:
• Read the documentation provided with the computer at this time also.
• If you try to force the wireless card the wrong way into the slot, it will
damage the wireless card and the projector.
Install the
driver.
(Page 28)
Computer
-27-
Install the
utilities.
(Page 35)
Wireless card
Use Wireless
manager to
make
network
settings.
(Page 37)