Light Source/Temperature/Filter Indicators; When An Indicator Lights Up - Panasonic PT-RQ32K Operating Instructions Manual

Chapter 6 Maintenance — Light source/temperature/filter indicators

Light source/temperature/filter indicators

When an indicator lights up

If a problem occurs inside the projector, the light source indicators <LIGHT1>/<LIGHT2>, temperature indicator
<TEMP>, or filter indicator <FILTER> will inform you by lighting or blinking in red. Check the status of the
indicators and take following measures.
Attention
f When switching off the projector to deal with problems, make sure to follow the procedure in "Switching off the projector" (x page 69).
Light source indicators <LIGHT1>/<LIGHT2>
Indicator status
f Some of the elements of the light
Lighting in red source are defective and the light
output has decreased.
f The light source is turned off since
Blinking in red
the projection lens cannot be
(1 time)
detected.
Blinking in red
f The light source does not light up,
(2 times)
or the light source turns off while the
Blinking in red
projector is in use.
(3 times)
Note
f If the light source indicators <LIGHT1>/<LIGHT2> are still lit or blinking after taking the measures, set the <MAIN POWER> switch to
<OFF>, and ask your dealer for repairs.
f The light source indicator corresponding to the light source being lit will light up in green if the projector is in projection mode and there is no
indication of problem by lighting or blinking in red.
Light source indicator <LIGHT1>
Status
f Turn the <MAIN POWER> switch to <OFF> (x page 69), and turn on the
power again.
f Turn off the power and mount the projection lens again. (x page 48)
f Turn the <MAIN POWER> switch to <OFF> (x page 69), and turn on the
power again.
f Turn the <MAIN POWER> switch to <OFF> (x page 69), and turn on the
power again.
Light source indicator <LIGHT2>
Temperature indicator <TEMP>
Filter indicator <FILTER>
Solution
ENGLISH - 211