Panasonic PT-RQ32K Operating Instructions Manual page 198

[Detail control] page
Click [Projector control] → [Detail control].
1 [MULTI DISPLAY MODE]
Switches the setting of the multi-display mode.
2 Control of the projector
The projector is controlled by clicking the buttons in the same
way as the buttons on the remote control. After control, the on-
screen display of the projector at the right of the control page is
updated.
3 [SUB MEMORY]
Switches the sub memory.
4 [SYSTEM DAYLIGHT VIEW]
Switches to system daylight view settings.
5 [FREEZE]
Temporarily pauses the image.
[LENS] page
Click [Projector control] → [Detail control] → [LENS].
1 [SET POSITION]
The lens position setting page is displayed.
2 [HOME POSITION]
Moves the projection lens to the home position.
3 [SHIFT]
Click asqw to adjust the lens shift (vertical position and
horizontal position).
The adjustment can be performed faster by holding down the
button for approximately three seconds or longer.
4 [FOCUS]
Press qw to adjust the focus.
The adjustment can be performed faster by holding down the
button for approximately six seconds or longer.
198 - ENGLISH
Chapter 5 Operations — Web control function
1
2
3
4
5
6
1
2
3
4
5
6
7
8
7
8
9
10
6 [WAVEFORM MONITOR]
Displays the waveform of the input signal.
7 [PROJECTION METHOD]
Switches the setting of the projection method.
8 [LENS]
Displays the [LENS] page.
9 [TEST PATTERN]
Displays the test pattern.
Click the test pattern to display in the projected image from the
patters displayed on the right side of the control page.
The display of the test pattern disappears if [Exit] is clicked.
10 [GET OSD]
Updates the on-screen display of the projector at the right of the
control page.
5 [ZOOM]
Click qw to adjust the zoom.
6 [LENS MEMORY SAVE]
Saves the current lens position (vertical position, horizontal
position, focus position, and zoom position). Click the number of
the lens memory to save.
7 [LENS MEMORY LOAD]
Loads the lens position (vertical position, horizontal position,
focus position, and zoom position). Click the number of the lens
memory to load.
8 [Back]
Returns to the [Detail control] page.