Panasonic PT-RQ32K Operating Instructions Manual page 216

Performing maintenance of the air filter unit
1) Wash the air filter unit. (Fig. 1)
i) Soak the air filter unit in cold or warm water and then lightly rinse it.
f Do not use cleaning tools such as brushes.
f When rinsing, hold the frame of the air filter unit without putting strong pressure on the filter unit.
ii) Rinse the air filter unit two to three times using fresh water each time.
f Insufficient rinsing may result in odors.
2) Dry the air filter unit. (Fig. 2)
f Let the air filter unit naturally dry off in a well-ventilated place where there is little dust and is not exposed to
direct sunlight.
f Do not dry using drying devices such as dryers.
f After the air filter is dried, proceed to "Attaching the air filter unit" (x page 216) next.
Attention
f After washing the air filter unit, dry it thoroughly before attaching it back to the projector. Attaching a wet unit will cause an electric shock or
malfunction.
f Do not disassemble the air filter unit.
Note
f Replace the air filter unit with a new Replacement Filter Unit (Model No.: ET-EMF330) (accessory/optional accessory) if it is damaged or if
the dirt does not come off even after washing.
Attaching the air filter unit
Tabs on the projector body (c)
Tabs on the projector body (d)
1) Attach the air filter unit to the projector. (Fig. 1)
f The air filter unit has no difference between top and bottom, but is two-sided. Match the protrusion position
of the air filter unit with the grooves on the projector body.
216 - ENGLISH
Chapter 6 Maintenance — Maintenance/replacement
Fig. 1
Grip on the air filter unit (a)
Protrusion of the air filter unit
Groove on the projector body
Fig. 1
Fig. 2
Groove on the projector body
Protrusion of the air filter
unit
Grip on the air filter unit
(b)
Air filter cover fixing screw
Air filter cover
Fig. 2