Setting up
Usable outlet
A grounded outlet supporting 220 V/15 A is required when using the projector.
Following illustration is an example of the shape of the usable outlet.
Attention
f Use the supplied power cord and ground at the outlet.
Installation mode
The installation modes of the projector are as follows. Set [FRONT/REAR]/[FLOOR/CEILING] in the
[PROJECTOR SETUP] menu → [PROJECTION METHOD] (x page 119) depending on the installation mode.
Setting on a desk/floor and projecting forward
Menu item
[FRONT/REAR]
[FLOOR/CEILING]
Mounting on the ceiling and projecting forward
Menu item
[FRONT/REAR]
[FLOOR/CEILING]
30 - ENGLISH
Chapter 2 Getting Started — Setting up
2P/3W 15 A 250 V
Setting on a desk/floor and projecting from rear
(Using the translucent screen)
Setting value
[FRONT]
[AUTO] or [FLOOR]
Mounting on the ceiling and projecting from rear
(Using the translucent screen)
Setting value
[FRONT]
[AUTO] or [CEILING]
Menu item
[FRONT/REAR]
[FLOOR/CEILING]
Menu item
[FRONT/REAR]
[FLOOR/CEILING]
Setting value
[REAR]
[AUTO] or [FLOOR]
Setting value
[REAR]
[AUTO] or [CEILING]