11.13
Greasing the steering head bearing
11.14
Removing the fuel tank
Danger
Fire hazard Fuel is highly flammable.
The fuel in the fuel tank expands when warm and can escape if overfilled.
–
Do not refuel the vehicle in the vicinity of open flames or lit cigarettes.
–
Switch off the engine for refueling.
–
Make sure that no fuel is spilled; particularly not on hot parts of the vehicle.
–
If any fuel is spilled, wipe it off immediately.
–
Observe the specifications for refueling.
11 SERVICE WORK ON THE CHASSIS
Guideline
Nut, steering
head
Nut, steering
head
–
Using a plastic hammer, tap lightly on the upper triple
clamp to avoid stresses.
–
Tighten screw
Guideline
Screw, top triple
clamp
–
Tighten screws
Guideline
Screw, top triple
clamp
–
Position the fuel tank breather
Finishing work
–
Check play of steering head bearing. (
–
Remove the motorcycle from the lift stand. (
–
Remove the lower triple clamp.
–
Install the lower triple clamp.
H02387-01
M20x1.5
10 Nm (7.4 lbf ft)
M20x1.5
9 Nm (6.6 lbf ft)
Only applies when
using:
Holding wrench for
steering head bearing
(45229050000)
3
.
M8
20 Nm (14.8 lbf ft)
2
.
M8
20 Nm (14.8 lbf ft)
1
in the steering stem.
p. 51)
(
p. 48)
(
p. 48)
p. 43)
53