Husqvarna TC 50 Owner's Manual page 84

12 BRAKE SYSTEM
82
–
Remove lock washer
–
Loosen screw
–
Remove screws
–
Carefully pull the brake caliper backward from the brake disc.
–
Remove screw
Warning
Danger of accidents Oil or grease on the brake
A00089-10
discs reduces the braking effect.
–
Always keep the brake discs free of oil and
grease.
–
Clean the brake discs with brake cleaner when
necessary.
–
Check the brake discs. (
–
Remove the brake linings.
–
Clean the brake caliper and brake caliper support.
–
Press the brake piston back into the basic position and
ensure that brake fluid does not flow out of the brake fluid
reservoir, sucking it away if necessary.
V00553-10
Warning
Danger of accidents Brake linings which have not
been approved alter the braking efficiency.
Not all brake linings are tested and approved for
Husqvarna motorcycles. The structure and friction
coefficient of the brake linings, and thus their brake
power, may vary greatly from that of original brake
linings.
V00553-11
If brake linings are used that differ from the original
equipment, compliance with the original homologa-
tion is not guaranteed. In this case, the vehicle no
longer corresponds to its condition at delivery and
the warranty shall be void.
–
Only use brake linings approved and
recommended by Husqvarna motorcycles.
–
Position the new brake linings.
Info
Always change the brake linings in pairs.
Ensure that the brake linings are correctly positioned
in the holding spring.
4
.
5
.
6
.
5
.
p. 77)