Installing The Main Silencer; Changing The Glass Fiber Yarn Filling Of The Main Silencer - Husqvarna TC 50 Owner's Manual

11 SERVICE WORK ON THE CHASSIS
11.34
11.35
66
K00673-10

Installing the main silencer

K00673-11

Changing the glass fiber yarn filling of the main silencer

Warning
Danger of burns The exhaust system gets very hot when the vehicle is driven.
–
Allow the exhaust system to cool down before performing any work on the vehicle.
Info
Over time, the fibers of the glass fiber yarn escape and the damper "burns" out.
Not only is the noise level higher, the performance characteristic changes.
Main work
–
1
Remove screw .
–
Remove screw 2 .
–
Pull off the main silencer from the manifold at rubber
3
sleeve .
Main work
–
Mount the main silencer with rubber sleeve
–
Mount the silent block with screw
Guideline
Remaining screws,
chassis
–
Position the collar bushings.
–
Mount and tighten screw
Guideline
Remaining screws,
chassis
Finishing work
–
Install the right side cover. (
–
Mount the seat. ( p. 63)
Preparatory work
–
Remove the seat. ( p. 63)
–
Remove the right side cover. (
–
Remove the main silencer. (
1
.
2
.
M6 10 Nm (7.4 lbf ft)
3
.
M6 10 Nm (7.4 lbf ft)
p. 58)
p. 57)
p. 65)