12.12
Adjusting steering head bearing play
12.13
Greasing the steering head bearing
12.14
Removing front fender
SERVICE WORK ON THE CHASSIS 12
Preparatory work
–
Raise the motorcycle with a lift stand. (
Main work
–
Loosen screws
–
Loosen and retighten screw
Guideline
Screw, top steering
head
–
Using a plastic hammer, tap lightly on the upper triple clamp
to avoid stresses.
H03689-10
–
Tighten screws
Guideline
Screw, top triple
clamp
–
Mount and tighten screw
Guideline
Screw, top
steering stem
Finishing work
–
Check the steering head bearing for play. (
–
Remove the motorcycle from the lift stand. (
–
Remove the lower triple clamp.
–
Install the lower triple clamp.
H02387-01
Preparatory work
–
Remove the headlight mask with the headlight. (
p. 56)
1
2
. Remove screw
.
3
.
M20x1.5
12 Nm (8.9 lbf ft)
1
.
M8
17 Nm (12.5 lbf ft)
2
.
M8
17 Nm (12.5 lbf ft)
(
p. 59)
(
p. 60)
®
Loctite
243™
p. 62)
p. 56)
p. 112)
63