Adjusting The Play Of The Steering Head Bearing; Greasing The Steering Head Bearing - Husqvarna TE 250i Owner's Manual

12.12

Adjusting the play of the steering head bearing

12.13

Greasing the steering head bearing

12 SERVICE WORK ON THE CHASSIS
–
Adjust the play of the steering head bearing.
( p. 63)
–
Check the steering head bearing and change if neces-
sary.
Finishing work
–
Remove the motorcycle from the lift stand. (
Preparatory work
–
Raise the motorcycle with a lift stand. (
Main work
–
Loosen screws
–
Loosen and retighten screw
Guideline
Screw, top steering
head
–
Using a plastic hammer, tap lightly on the upper triple clamp
to avoid strains.
K00932-10
–
Tighten screws
Guideline
Screw, top triple
clamp
–
Mount and tighten screw
Guideline
Screw, top
steering stem
Finishing work
–
Check the play of the steering head bearing. (
–
Remove the motorcycle from the lift stand. (
–
Remove the lower triple clamp.
–
Install the lower triple clamp.
H02387-01
p. 56)
1 2
. Remove screw .
3
.
M20x1.5 12 Nm (8.9 lbf ft)
1
.
M8 17 Nm (12.5 lbf ft)
2 .
M8 17 Nm (12.5 lbf ft)
( p. 59)
( p. 60)
p. 56)
®
Loctite 243™
p. 62)
p. 56)
63