–
Remove screws
–
Take off cover
–
Press the brake piston back into the basic position and
ensure that brake fluid does not flow out of the brake fluid
reservoir, sucking it away if necessary.
H01448-11
–
Position the new brake linings.
Info
Always change the brake linings in pairs.
Ensure that the brake linings are correctly positioned
in the holding spring.
–
Position the brake caliper on the brake disc.
The brake linings are correctly positioned.
–
H01450-10
Attach the brake line to holder
–
Mount and tighten screws
Guideline
Rear brake
caliper screw
–
Mount screw
Guideline
Screw, brake linings
–
Mount lock washer
S00880-10
–
Check the brake discs. (
–
Operate the foot brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
point.
–
Add brake fluid up to level
Guideline
A
Level
(brake fluid level
below reservoir rim)
Brake fluid DOT 4 (
H01654-10
–
Position the cover with the washer and membrane.
–
Mount and tighten the screws.
Info
Clean up overflowed or spilled brake fluid immediately
with water.
Finishing work
–
Remove the motorcycle from the lift stand. (
12 BRAKE SYSTEM
5
.
6
7
with washer
and membrane
4
.
3
.
M6
10 Nm (7.4 lbf ft)
2
.
M5
8 Nm (5.9 lbf ft)
1
.
p. 77)
A
.
10 mm (0.39 in)
p. 127)
8
.
®
Loctite
243™
p. 43)
89