Adjusting The Play Of The Steering Head Bearing; Greasing The Steering Head Bearing - Husqvarna TX 125 Owner's Manual

12 SERVICE WORK ON THE CHASSIS
12.12
12.13
60

Adjusting the play of the steering head bearing

H02509-10

Greasing the steering head bearing

H02387-01
–
Adjust the play of the steering head bearing.
( p. 60)
–
Check the steering head bearing and change if neces-
sary.
Finishing work
–
Remove the motorcycle from the lift stand. (
Preparatory work
–
Raise the motorcycle with a lift stand. (
Main work
–
1
Loosen screws . Remove screw
–
Loosen and retighten screw
Guideline
Screw, top steering
head
–
Using a plastic hammer, tap lightly on the upper triple clamp
to avoid strains.
–
1
Tighten screws .
Guideline
Screw, top triple
clamp
–
Mount and tighten screw
Guideline
Screw, top M8
steering stem
Finishing work
–
Check the play of the steering head bearing. (
–
Remove the motorcycle from the lift stand. (
–
Remove the lower triple clamp.
–
Install the lower triple clamp.
p. 53)
p. 53)
2
.
3
.
M20x1.5 12 Nm (8.9 lbf ft)
M8 17 Nm (12.5 lbf ft)
2 .
17 Nm (12.5 lbf ft)
Loctite
p. 59)
p. 53)
( p. 56)
( p. 57)
®
243™