Dmx Channel Mode - ETC Releve Spot Installation Manual

ETC Installation Guide
Relevé Spot

DMX Channel Mode

Relevé Spot has two modes of operation, which are accessible in the Control Settings menu from
the user interface. A full listing of control channels and timing data for the selected mode of
operation is available on the ETC website etcconnect.com/ReleveSpot/DMX-Channel-Map.
Standard Mode utilizes 20 channels of control. This is the default setting.
•
Direct Mode utilizes 25 channels of control.
•
Note:
When operating in Standard Mode, each luminaire makes accommodations for the specific
LEDs in its array and produces output that is consistent with other luminaires, whether or
not they utilize LEDs from the same production batch.
Operating in Direct Mode bypasses this calibration, and multiple luminaires may produce
slightly different outputs when controlled as a group.
Standard Mode
Channel Parameter
1 Intensity
2 Red
3 Green
4 Blue
5 Strobe
6 Pan Coarse
7 Pan Fine
8 Tilt Coarse
9 Tilt Fine
10 Gobo Mode
11 16-bit Gobo Index Coarse
12 16-bit Gobo Index Fine
13 Ani-gobo Mode
14 Ani-gobo Index
15 Focus Coarse
16 Focus Fine
17 Zoom
18 Iris
19 Frost
20 Configuration
Relevé Spot
The color output of all Relevé Spot luminaires is calibrated at the factory.
Channel
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
Direct Mode
Parameter
Intensity
Red
Green
Blue
Lime
Strobe
Pan Coarse
Pan Fine
Tilt Coarse
Tilt Fine
Gobo Mode
16-bit Gobo Index Coarse
16-bit Gobo Index Fine
Ani-gobo Mode
Ani-gobo Index
Focus Coarse
Focus Fine
Zoom
Iris
Frost
Page 7 of 8
Channel Parameter
21 Configuration
22 Pan/Tilt Speed
23 Zoom/Focus Speed
24 Reserved
25 Beam Speed
ETC