Error Codes; Rdm Values - ETC ColorSource CYC Installation Manual

ETC Installation Guide
ColorSource CYC v1.6

Error codes

There are three error codes that may be shown on the user interface.

•
with the color calibration. The fixture will need to be returned to the
ETC factory; contact your local dealer to set up a repair.

•
fixture has gone into over-temperature protection mode to avoid
damaging the fixture. Once the fixture has self-cooled, the error will
automatically clear.

•
upgraded fixtures have a software issue. Reload software to clear the
error. If the error persists, contact ETC.

RDM values

Manufacturer ID: 0x6574 (Electronic Theatre Controls)
Model ID: 0x0215 (ETC ColorSource CYC)
Parameter
DMX Start
Address
Personality ID
Output
Frequency
ColorSource CYC v1.6
: Screen toggles between
: Screen toggles between
: Screen toggles between
RDM PID
0x00F0
0x00E0
0x8123
Page 10 of 12
 
and to indicate a problem
 
and to indicate that the
 
and
Value
Range = 1–512
1 = 5 Channel
2 = Direct
3 = 1 Channel
4 = RGB
0 = Standard (1.2 kHz)
1 = High (25 kHz)
to indicate that the
ETC