Restore Factory Defaults; Error Codes - ETC ColorSource Spot jr v2.0 Installation Manual

ETC Installation Guide
ColorSource Spot jr v2.0/v3.0
4. Press the Mode button to start the update process.
The display alternates between
•
updating.
The display blinks once to indicate that the update is complete.
•
5. Reconnect DMX In on the fixture.

Restore Factory Defaults

Press and hold the Mode button, Up button, and Down button
simultaneously for 5 seconds. The DMX start address will blink once to
confirm that defaults have been restored.

Error Codes

There are three error codes that may be shown on the user interface.
CAL
: Screen toggles between
•
the color calibration. The fixture will need to be returned to the ETC
factory; contact your local dealer to set up a repair.
OtP
: Screen toggles between
•
has gone into over-temperature protection mode to avoid damaging the
fixture. Once the fixture has self-cooled, the error will automatically clear.
No App
•
upgraded fixtures have a software issue. Reload software to clear the
error. If the error persists, contact ETC (visit etcconnect.com/contactETC).
ColorSource Spot jr
: Screen toggles between
Udt
and the percentage complete while
CAL Err
and to indicate a problem with
OtP Err
and to indicate that the fixture
no APP
and
Page 11 of 16
to indicate that the
ETC