Switching On/Off - Dog trace d–control 200 mini User Manual

Switching ON/OFF

SWITCHING THE TRASNMITTER ON/OFF
Switching on: Press down for 1 second the

The LCD display indicates that the unit is active.
Switching off: Again, press down for 1 second the

SWITCHING THE RECEIVER ON/OFF
A magnet located at the lower part of the transmitter is used to activate or deactivate the magnetic
switch located in the receiver.
Switching on: approach the low area of the transmitter where the magnet is located until coming

close to the indicator located on the receiver (see the picture), hold for 1 second, the receiver
LED indicator will flash in green indicating the receiver is ON.
Switching off: approach the low area of the transmitter where the magnet is located until coming

close to the indicator located on the receiver, hold for 1 second,
the receiver LED indicator will flash from green to red indicating
the receiver is OFF.
To extend the battery life it is necessary to switch off both receiver and
transmitter after the training is finished. If the battery will not be in use
for a month or longer, it is recommended that it is removed from the
receiver.
Switching ON/OFF the transmitter/Programming the transmitter with the receiver
8
button on the transmitter.
button on the transmitter.