Transmitter - Button Functions - Dog trace d–control 200 mini User Manual

Transmitter - button functions

The d–control 200 transmitter is designed to operate with two separate receivers (dog A and dog B).
The selected level of stimulations can be different for each receiver.
Button - Tone signal
The receiver emits a beeping noise when a "Tone button" is pressed. If the button is not released after
10 seconds, the tone will automatically turn off. While pressing, an indicator of the radio transmission
will appear on the LCD display of the transmitter; the indicator light on the receiver goes from flashing
green to permanent green for as long as the button is pressed.
Button - Continuous stimulation
Pressing the "Stimulation button" gives continuous electric stimulation transmitted by the two contact
points located on the receiver as long as the button is pushed. If the button is not released after 4
seconds, the stimulation will automatically turn off as a safety feature. The receiver will be ready to be
reactivated once the button has been released. While pressing, an indicator of the radio transmission
will appear on the LCD display of the transmitter; the indicator light on the receiver goes from flashing
green to permanent red for as long as the button is pressed.
Button - Booster
Pressing the "Booster button" gives continuous electric stimulation transmitted by the two contact
points located on the receiver as long as the button is pushed. If the button is not released after 4
seconds, the stimulation will automatically turn off as a safety feature. The receiver will be ready to be
reactivated once the button has been released. While pressing, an indicator of the radio transmission
will appear on the LCD display of the transmitter; the indicator light on the receiver goes from flashing
green to permanent red. You can set the level of the Booster stimulation by 0-5 intensity levels higher than
the level you are using on the "Stimulation button". As a result, you do not need to press the
button.
10