Switching On/Off - Dog trace d-control 640 Manual

INSERTION (REPLACEMENT) OF THE BATTERY IN THE TRANSMITTER
Remove the cover of the battery compartement and insert 2 LR6 alcaline batteries. Mind the correct
polarity marked in the battery compartement.
Replace the cover and tighten the screw.
Checking the battery status
Look at the LCD display to check the battery status:
Fully charged battery: full battery symbol shines in the LCD permanently in on state.
Weak battery: LCD display indicates battery capacity decrease. In case the battery symbol is empty,
insert new LR6 batteries according to the instructions above.
Make sure that the receiver works correctly.
NOTICE: You can also use rechargeable batteries in the remote controller. They do not provide
enough voltage for correct battery status indication on the LCD.
CAUTION: Always switch off the remote controller before battery removal, remove the battery and
shortcut battery contacts using a metal tool.

Switching ON/OFF

SWITCHING THE TRASNMITTER ON/OFF
Switching on: Press down for 1 second the
that the unit is active.
Switching off: Again, press down for 1 second the
button on the transmitter. The LCD display indicates
button on the transmitter.
29