Dog trace d–control 200 mini User Manual page 11

Programming the "Booster button":
press the selection button

on the LCD display.
press the or

press the selection button

select dog B using the

programming "Booster function" for the second receiver).
Up/Down control buttons
The control buttons are used for quick adjustment of the stimulation level of the receiver. The selected
intensity level is shown on the LCD display. There are 20 stimulation levels with 0 being the lowest and
19 being the highest. When any button is pressed the LCD display lights up for three seconds.
Dog selection buttons
The control buttons A and B are used for quick dog selection when using the device for training two
dogs simultaneously. It is possible to set different level of stimulation for each dog.
for approximately 5 seconds until the level of stimulation flashes
button to increase or decrease the level of stimulations (0-5).
to confirm the level selected.
button on the transmitter and proceed in the same way (applicable when
11