Troubleshooting - Dog trace d–control 200 mini User Manual

conditions, water can cause irreversible damage to your transmitter. The receiver is waterproof. The
receiver case is provided with a seal that forms a waterproof barrier between the lid and main housing
of the case. If the seal is loose, out of alignment or twisted, it will compromise the waterproof integrity
of the case. Lubricating the seal with a thin layer of silicone grease will increase its lifespan. We
recommend replacing the seal in the receiver every year. It is recommended to remove the battery
from the receiver, if the device will not be in use for a month or longer.

Troubleshooting

If your device seems to operate improperly, read this manual again, check the receiver battery and

replace it if necessary.
Try to initialize the receiver by removing the battery from the battery holder in the receiver, then

use a metal tool (e.g. a screwdriver, scissors, etc.) and short-circuit both contacts of battery holder
for approximately two seconds, and then put the battery back in its place observing the correct
polarity. A beep sound is emitted indicating the correct installation of the battery.
If the problem still persists, try to program the transmitter

with receiver again according to the instructions in this
manual.
If the problem still persists, contact the dealer.

16
While using the device, it is recommended to check periodically
TIP
that screws in the receiver lid are tightened correctly.
Short-circuit of the receiver