How To Check That Your D-Control Works Correctly; Using D-Control Training Collar In Winter - Dog trace d–control 200 mini User Manual

How to check that your d–control works correctly
You can check anytime that your d-control is operating
correctly.
Before doing so, make sure that the receiver is switched

off.
Place the test discharge lamp in contact with each of the

contact points as shown in the picture.
Switch on the transmitter and receiver.

Press the stimulation button and modify the level of

intensity of the stimulations: the test lamp will come on
with more or less intensity according to the selected
intensity level.
Using d–control training collar in winter
When using d-control in winter, please keep in mind:
Low humidity – causes less skin conductivity. It is necessary to provide better conductivity

between the electrodes of the receiver and the dog's skin. This can be achieved by lubricating the
dog's skin in the touch points of contact points with Vaseline, baby oil, hand lotion, etc.
Heavier dog's coat – it is necessary to tighten the collar so that the permanent contact with the

dog's skin is ensured. If the coat is too thick, it is recommended to choose a longer type of contact
points.
Battery properties change – temperatures below 0 °C slow down chemical reactions in batteries.

To ensure a performance of repetitive stimulations (especially of higher levels), it is recommended
to insert a new battery into the receiver for the winter time. During the training, observe
continuously dog's reactions and increase the stimulation level as needed.
12
Location of the test lamp attachment