Wireless Keypad: Arming And Disarming; Arm With A Keypad; Disarm With A Keypad; Activate A Fire Emergency - 2gig Technologies GC2 User Manual

GC2 Wireless Security System | User Guide
WIRELESS KEYPAD: ARMING
AND DISARMING
Your system may be equipped with one or
more wireless keypads. Up to four (4)
wireless keypads can be used to control the
system remotely from the main Control
Panel.
Two types of wireless keypads are available.
A wireless keypad without a screen, and a
wireless touch screen keypad.
The wireless touch screen keypad operates
virtually the same as the Control Panel. Each
standard wireless keypad has buttons for
entering user codes, Stay and Away mode
buttons, and Fire and Police emergency
buttons.
Check the See "Installer Programmed
Options" on page 40. section in this guide to
verify which 24‐hour Fire and Police
emergency buttons have been enabled by
the installer.

Arm with a Keypad

Stay Mode
To arm the system to Stay mode using a
wireless keypad:
At the Home screen, tap Security > Arm.
1
Enter a valid user code.
2
Tap the Stay button.
3
If Quick Arming has been programmed
4
by your installer, just tap the Stay
button.
NOTE: If any perimeter door or window
sensors are open, the system does
not allow arming to Stay mode
with a wireless keypad. All open
sensors must be bypassed at the
Control Panel first.
20 Copyright © 2016 Nortek Security & Control
Away Mode
To arm the system to Away mode using a
wireless keypad:
At the Home screen, tap Security.
1
At the Security screen, tap Arm.
2
Enter a valid user code.
3
Tap the Away button.
4
If Quick Arming has been programmed
5
by your installer, just tap the Away
button
NOTE: If any perimeter door or window
sensors are open, the system does
not permit you to use a wireless
keypad to arm the system in Away
mode. All open sensor‐protected
doors and windows must either be
closed or bypassed at the Control
Panel before arming with a
wireless keypad.

Disarm with a Keypad

To disarm the system from Stay or Away
mode, enter a user code.

Activate a Fire Emergency

To trigger an emergency fire alarm using a
wireless keypad, press and hold the Fire
button for two (2) seconds.
NOTE: To use a wireless keypad to
trigger a fire alarm, this option
must already be enabled by your
installer.

Activate a Police Emergency

To trigger an emergency police alarm using a
wireless keypad, press and hold the Police
button for two (2) seconds.
NOTE: To use a wireless keypad to
trigger a police alarm, this option
must already be enabled by your
installer.