Wireless Keypad Arming And Disarming; Wireless Keypad Arming To Stay Mode; Wireless Keypad Arming To Away Mode; Wireless Keypad Disarming - 2gig Technologies Go!Control 2GIG-CNTRL2 User Manual

Wireless Keypad Arming and Disarming

Your system may be equipped with one or more wireless keypads. Up
to four wireless keypads can be used to control the system remotely
from the main Control Panel.
Two types of wireless keypads are available. The standard
wireless keypad, and the wireless touch screen keypad.
The wireless touch screen keypad operates virtually the
same as the Control Panel. Use the following instructions for
operating the standard wireless keypad.
Each standard wireless keypad has buttons for entering User Codes,
STAY and AWAY mode buttons, and FIRE and POLICE emergency
buttons.
Check the Installer Set Options section at the rear of this manual
to verify which 24-hour FIRE and POLICE emergency buttons have
been enabled by the installer:

Wireless Keypad Arming to Stay Mode

• To arm the system to Stay Mode using a wireless keypad, enter a User Code and press the
STAY button. (If Quick Arming has been allowed by the installer, just press the STAY button.)
✓ NOTE: If there are open perimeter doors or windows, the system will not allow arming to Stay
Mode with a wireless keypad. All open sensors must be bypassed at the Control Panel fi rst.

Wireless Keypad Arming to Away Mode

• To arm the system to Away Mode using a wireless keypad, enter a User Code and press the
AWAY button. (If Quick Arming has been allowed by the installer, just press the AWAY button.)
✓ NOTE: If there are open perimeter doors or windows, the system will not allow arming to
Away Mode with a wireless keypad. All open sensor-protected doors and windows must
either be closed or bypassed at the Control Panel before arming with a wireless keypad.

Wireless Keypad Disarming

• To disarm the system from Stay or Away Mode using a wireless keypad, just enter a User Code.

Wireless Keypad Fire Emergency

• To trigger a emergency fi re alarm using a wireless keypad, press the FIRE
button for two seconds. (This option must be enabled by the installer.)

Wireless Keypad Police Emergency

• To trigger a emergency police (panic) alarm using a wireless keypad, press the
POLICE button for two seconds. (This option must be enabled by the installer.)
Burglary Protection
Standard Wireless Keypad
Wireless Touch Screen Keypad
17