Silent Control In Stay Mode; Arming To Stay Mode - 2gig Technologies GC2 User Manual

GC2 Wireless Security System | User Guide
understand the options that have been
programmed for your system.
SILENT CONTROL IN STAY
MODE
Three options for silencing the beeps and
announcements are available when arming
or disarming the system in Stay Mode.
• At the Home or Security screen, tap the
Silent Control button.
• At the Ready to Arm screen, check the
Silent Exit box.
• On the Exit Delay screen, tap Silence.
Selecting any of these options silences the
Control Panel beeps and announcements,
and when arming, selecting the option
doubles the length of the Exit Delay.

Arming to Stay Mode

Use Stay Mode to arm the system when
anyone is at home. Stay Mode normally has
an Entry Delay so a user with a user code can
re‐enter without causing an alarm.
Close all protected perimeter doors and
1
windows before arming.
Verify that the
2
Panel is lit GREEN indicating that the
system is ready to arm. The Security and
Arm buttons on the display are GREEN
when all sensors are closed.
14 Copyright © 2016 Nortek Security & Control
button on the Control
NOTE: If you want to arm the system
quietly without sounding any
announcements, tap
performing these steps:
• At Ready to Arm screen, check the
Silent Exit box.
Or
• During exit delay tap Silence.
At the Security or Menu screen, tap
3
Arm.
NOTE: If any perimeter door or window
sensors are open, the Bypass
screen appears. Close all the
sensors displayed or tap Bypass All
to force bypass the displayed
sensors.
NOTE: Bypassed sensors do not trigger
an alarm. (To bypass sensors, enter
a user code unless the installer has
set the system for Quick Bypass).
On the Ready to Arm screen, check the
4
Entry Delay box when arming the system
in Stay mode.
If no one is expected to re‐enter, the
system can be armed without an Entry
Delay. All perimeter doors will trigger the
alarm instantly. To arm with instant
alarms for all exit/ entry perimeter
doors, clear the checkmark from the
Entry Delay box.
Tap Stay to arm the system.
5
NOTE: To arm the system, you may
need to enter a user code if your
installer has turned off the
system's Quick Arming feature.
The system will arm and shows the Exit
6
Delay counting down. When the Exit
Delay expires, the system is fully armed
in the Stay mode.
before