24-Hour Emergency Functions; Quick Arming; Quick Bypass; Quick Exit - 2gig Technologies GC2 User Manual

24-Hour Emergency Functions

The system can be configured to display
three 24‐hour emergency buttons on the
Control Panel: Panic, Fire, and Emergency.
The installer can set which emergency
buttons on the Control Panel are active.
 Panic (Audible)
 Panic (Silent)
 Fire
 Emergency

Quick Arming

Quick Arming allows you to arm your system
without having to enter a user code. When
you tap the Stay or Away button, the system
will start to arm without requesting a user
code.
• Off
• On

Quick Bypass

Normally sensors that are open at the time
the system is armed will require force
bypassing by entering your user code. The
system can be set so a user code is not
required to bypass open sensors when the
system is armed.
• Off
• On

Quick Exit

The Quick Exit option allows you to start the
Exit Delay while the system is armed. This
allows you to leave the premises without
having to disarm and rearm the system.
When the Quick Exit option is on, a Quick
Exit button will display on the Security
screen. Tap the button to start the Exit Delay.
Installer Programmed Options
After Quick Exit, the system will fully re‐arm
in the mode that it was in before (Stay or
Away mode).
• Off
• On

Auto Un-bypass

Normally, sensors manually bypassed with
the User Toolbox will automatically have
their bypasses removed when the system is
disarmed. The system can be set so sensors
that have been manually bypassed will stay
bypassed until the bypass is manually
removed
• Off
• On

Auto Stay

The Auto Stay option will change the arming
mode if no one exits after arming the system
in Away mode. When the system is armed in
the Away mode the Exit Delay will begin.
With the Auto Stay option on, if a designated
exit/entry door does not open and close
during the Exit Delay, the system will arm in
the Stay mode instead of the Away mode.
• Off
• On

Key Fob Sound

The system can be set so when it is armed or
disarmed by a wireless key fob, a beep will
sound through the internal and external
sounders to indicate that the key fob's signal
was received. This helps in installations
where the Control Panel is not visible or
there are no other system status indications
at the key fob's location.
• Off
• On
Copyright © 2016 Nortek Security & Control 41