Optional 2-Way Voice Communications; Key Fob: Arming And Disarming; Arm With A Key Fob; Disarm With A Key Fob - 2gig Technologies GC2 User Manual

Optional 2-Way Voice
Communications
2‐way voice communications provides a
method for alarm verification and can
provide emergency assistance. The Control
Panel contains a built‐in microphone that
can monitor sounds around the area of the
Control Panel. The built‐in microphone and
speaker allow 2‐way voice communications
with a Central Station operator after an
alarm. The operator can converse with
people in the premises through the Control
Panel's speaker and microphone.
Your installer can set the system to use 2‐
way voice communications after an alarm
and/or after a panic alarm is triggered.
NOTE: If a panic alarm or sensor is set
for a silent alarm, the operator can
only listen and will not be able to
talk. This is for your protection.
KEY FOB: ARMING AND
DISARMING
Your system may be equipped with one or
more wireless key fobs. Up to eight (8) key
fobs can be used to control the system
remotely. Each key fob has four (4) buttons
and can perform five (5) functions. A user
code is not required when arming or
disarming the system with a wireless key fob.
Several key fob options can be set by the
installer. See "Installer Programmed Options"
on page 40.

Arm with a Key Fob

Stay Mode
To arm the system to Stay mode using a key
fob, tap the Stay button.
NOTE: Depending on setup options, if
any perimeter doors or windows
are open, the system may not
allow arming to Stay mode with a
wireless key fob. See "Installer
Programmed Options" on page 40.
Away Mode
To arm the system to Away mode using a key
fob, tap the button.
NOTE: Depending on setup options, if
any perimeter doors or windows
are open, the system may not
allow arming to Away mode with a
wireless key fob. See "Installer
Programmed Options" on page 40.

Disarm with a Key Fob

To disarm the system from Stay or Away
mode sing a key fob, tap the Disarm
button.
NOTE: To use your key fob to disarm
your system, this option must
already be enabled by your
installer.

Activate the Emergency Alarm

To trigger an emergency alarm using a key
fob, press and hold the
Disarm button at the same time for 5
seconds.
NOTE: If an emergency alarm is
triggered by a key fob, it cannot be
stopped using the key fob Disarm
button. The alarm must be
canceled at the Control Panel.

Activate the Auxiliary Output

To trigger the Control Panel's auxiliary
output, tap the Auxiliary button.
If you use the Auxiliary button, the auxiliary
output controls the _________________.
Copyright © 2016 Nortek Security & Control 19
Burglary Protection
Away button and