Check the option that you want for the
6
sensor, then tap Ok.
When you are finished, tap Back.
7
ADJUSTING THE
BRIGHTNESS/VOLUME
You can adjust the brightness of the Control
Panel's display and the volume of the
system's speaker that is best suited to your
installed system.
To set the brightness and volume:
At the Home screen, tap Security.
1
At the Security screen, tap Menu.
2
At the Menu screen, tap Toolbox.
3
Enter the master user code to gain
4
access to the Toolbox.
At the Toolbox (1 of 3) screen tap
5
Brightness/Volume. You can set the
brightness using the top bar. Adjust the
level from 1 to 12 using the buttons on
each end of the bar.
You can set the speaker volume for the
6
chimes and announcements on the
bottom bar. Adjust the level from 1 to 12
using the buttons on each end of the bar.
NOTE: The volume setting does not
effect the alarm sounder volume.
When you are finished, tap Ok.
7
ADJUSTING THE BACKLIGHT
TIMEOUT
The backlight timeout sets the length of time
that the display stays lit after use. You can
adjust the backlight to 30 seconds, 1, 2, 5, or
10 minutes, or to always (to light the display
at all times).
NOTE: To conserve the Control Panel's
backup battery, during an AC
power failure, the display goes
dark after 30 seconds regardless of
this setting.
To set the display backlight time:
At the Home screen, tap Security.
1
At the Security screen, tap Menu.
2
At the Menu screen, tap Toolbox.
3
Enter a valid user code to gain access to
4
the Toolbox.
At the Toolbox (1 of 3) screen, tap the →
5
arrow.
At the Toolbox (2 of 3) screen, tap
6
Backlight Time‐out.
Choose one of the display backlight
7
times and tap Ok.
CLEANING THE TOUCH
SCREEN
There is a special option for the Control
Panel that enables you to clean the touch
screen display. The option disables the touch
screen for 30 seconds so the display can be
cleaned with a dry, soft cloth.
To disable the touch screen for cleaning:
At the Home screen, tap Security.
1
At the Security screen, tap Menu.
2
At the Menu screen, tap Toolbox.
3
Enter a valid user code to gain access to
4
the Toolbox.
At the Toolbox (1 of 3) screen, tap the →
5
arrow.
Copyright © 2016 Nortek Security & Control 37
System Toolbox