Touch Screen Calibration; Set Date And Time - 2gig Technologies GC2 User Manual

GC2 Wireless Security System | User Guide
At the Toolbox (2 of 3) screen, tap Clean
6
Screen.
NOTE: The Display Cleaning screen
appears for 30 seconds. It shows
the time remaining. The touch
screen is locked during this time.
When the timer expires, the
system returns to the Toolbox
screen.

TOUCH SCREEN CALIBRATION

To calibrate the display:
At the Home screen, tap Security.
1
At the Security screen, tap Menu.
2
At the Menu screen, tap Toolbox.
3
Enter a valid user code to gain access to
4
the Toolbox.
At the Toolbox (1 of 3) screen, tap the →
5
arrow.
At the Toolbox (2 of 3) screen, tap
6
Calibrate Touch Screen.
38 Copyright © 2016 Nortek Security & Control
The touch screen displays a cross on the
screen. Touch the center of the cross.
Repeat with the next 2 crosses that
appear.
When calibration has been successful, a
7
completion screen appears. To finish and
return to the Toolbox screen, tap Ok.

SET DATE AND TIME

The Control Panel has a built‐in clock and
calendar. The Home screen displays the time
and date. The time and date are also used
for the system history and event logs that
store data on system events.
NOTE: During installation, your installer
can set the system to automatically
adjust for daylight saving time if it's
observed in your location.
NOTE: The time and date are
automatically set through the
cellular radio by the Central Station
if your Control Panel has a cellular
radio installed.
To set the date and time:
At the Home screen, tap Security.
1
At the Security screen, tap Menu.
2
At the Menu screen, tap Toolbox.
3
At the Toolbox (1 of 3) screen, tap the →
4
arrow.
At the Toolbox (2 of 3) screen, tap Set
5
Date or Set Time.