Removing The Riser 1 Blank - Dell DR4300 System Owner's Manual

3. Follow the procedure listed in the After working inside your system section.
4. Install any device drivers required for the card as described in the documentation for the card.
Related tasks
Before working inside your system
Removing expansion card risers
Installing expansion card risers
After working inside your system
Related reference
Safety instructions

Removing the riser 1 blank

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow
the safety instructions that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Remove the expansion card riser.
Steps
Press the tabs on the riser 1 blank and push the riser 1 blank out of the chassis.
Figure 36. Removing the riser 1 blank
a. slot on the chassis
b. tab (2)
c. riser 1 blank
Installing and removing system components 93