Removing The Riser 1 Blank - Dell PowerEdge R730xd Owner's Manual

4. Install any device drivers required for the card as described in the documentation for the card.
Related Links
Safety instructions
Before working inside your system
Removing expansion card risers
Installing expansion card risers
After working inside your system

Removing the riser 1 blank

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Remove the expansion card riser.
Steps
Press the tabs on the riser 1 blank and push the riser 1 blank out of the chassis.
Figure 56. Removing the riser 1 blank
1. slot on the chassis 2. tab (2)
135