HEIDENHAIN TNC 640 User Manual page 821

Test Run and Program Run | Test run
The control then displays the following soft keys:
Soft key Functions
Reset the blank form, reset the previous tool
data and test the entire program
Test the entire program
Test each NC block individually
Executes the Test Run until block N
Stop test run (this soft key only appears if you
have started the test run)
You can interrupt and continue the test run at any time, even within
fixed cycles. In order to continue the test, the following actions
must not be performed:
Selecting another block with the arrow keys or the GOTO key
Making changes to the program
Selecting a new program
HEIDENHAIN | TNC 640 | Conversational Programming User's Manual | 10/2017
19
821