HEIDENHAIN TNC 640 User Manual page 459

Programming Q Parameters | String parameters
Reading system data
With the function SYSSTR you can read system data and store
them in string parameters. You select the system data through a
group number (ID) and a number.
Entering IDX and DAT is not required.
Group name, ID no.
Program information, 10010
Channel data, 10025
Values programmed in the tool
call, 10060
Kinematics, 10290
Current system time, 10321
Touch-probe data, 10350
Data for pallet machining, 10510
NC software version, 10630
Information for unbalance cycle,
10855
Tool data, 10950
HEIDENHAIN | TNC 640 | Conversational Programming User's Manual | 10/2017
Number Meaning
1 Path of the current main program or pallet program
Path of the cycle selected with CYCL DEF 12 PGM
3
CALL
Path of the program selected with SEL PGM
10
1 Channel name
1 Tool name
Kinematics programmed in the last FUNCTION MODE
10
block
1 - 16
50 Probe type of the active touch probe TS
70 Probe type of the active touch probe TT
73 Key name of the active touch probe TT from MP
activeTT
1 Pallet name
2 Path of the selected pallet table
10 Version identifier of the NC software version
1 Path of the unbalance calibration table belonging to
the active kinematics
1 Tool name
2 DOC entry of the tool
3 AFC control setting
4 Tool-carrier kinematics
1: DD.MM.YYYY hh:mm:ss
2 and 16: DD.MM.YYYY hh:mm
3: DD.MM.YY hh:mm
4: YYYY-MM-DD hh:mm:ss
5 and 6: YYYY-MM-DD hh:mm
7: YY-MM-DD hh:mm
8 and 9: DD.MM.YYYY
10: DD.MM.YY
11: YYYY-MM-DD
12: YY-MM-DD
13 and 14: hh:mm:ss
15: hh:mm
10
459