Method To Set Indoor Unit Function Dn Code - Toshiba MMY-MAP0804HT8-E Service Manual

6-5. Method to Set Indoor Unit Function DN Code

(When performing this task, be sure to use a wired remote controller.)
<Procedure> To be performed only when system at rest
1
Push the
least 4 seconds.
The unit No. displayed first is the address of the header indoor unit in group
control.
Then the fan and louver of the selected indoor unit move.
2
Each time the "Select unit" side of the
one of the indoor unit Nos. under group control is displayed in
turn. Then the fan and louver of the selected indoor unit move.
3
Use the
desired function.
4
Use the
with the selected function.
5
Push the
steady.)
• To change the selected indoor unit, go back to step
• To change the selected function, go back to step
6
When the
Downloaded from www.Manualslib.com
+ + buttons simultaneously and hold for at
button to select the CODE No. (DN code) of the
button to select the desired SET DATA associated
button. (The display changes from flashing to
button is pushed, the system returns to normal off state.
manuals search engine
UNIT LOUVER
button is pressed,
2
.
3
.
99
TEMP. ON / OFF
TIMER SET FAN MODE
TIME SAVE VENT
FILTER
RESET TEST SET CL SWING/FIX UNIT LOUVER
5 4
3
6 1 2