Method To Set Indoor Unit Function Dn Code - Toshiba Carrier MMD-AP0246HPUL Service Manual

8-5. Method to set indoor unit function DN code

(When performing this task, be sure to use a wired remote controller.)
<Procedure> To be performed only when system at rest
1
SET
Push the + +
least 4 seconds.
The unit No. displayed first is the address of the header indoor unit in group
control.
Then the fan and louver of the selected indoor unit move.
2
UNIT LOUVER
Each time the
one of the indoor unit Nos. under group control is displayed in
turn. Then the fan and louver of the selected indoor unit move.
3
Use the button to select the CODE No. (DN code) of the
TEMP.
desired function.
4
Use the button to select the desired SET DATA
associated with the selected function.
5
SET
Push the button. (The display changes from flashing to
steady.)
• To change the selected indoor unit, go back to step
• To change the selected function, go back to step
6
SET
When the button is pushed, the system returns to normal
off state.
CL
buttons simultaneously and hold for at
button (left side of the button) is pressed,
3
2
.
.
- 33 -
CODE No.
10
SET DATA SETTING TEST
00 01
UNIT No.
1-1
R.C. No.
TEMP. ON / OFF
TIMER SET FAN MODE
TIME SAVE VENT
FILTER
RESET TEST SET CL SWING/FIX UNIT LOUVER
5 4
3
1 2
6