Toshiba MMY-MAP0804HT8-E Service Manual page 135

4
Push the TIME
to that you want.
5
Push the
6
Push the
change.
Repeat steps
7
Push the
8
If the addresses have been changed correctly, push the
M To change all the indoor unit addresses using an arbitrary wired remote controller.
(The method is available when the addresses have already been set automatically.)
(When communication wirings of 2 or more refrigerant lines are interconnected for central control)
NOTE
You can change the addresses of indoor units in each refrigerant line using an arbitrary wired remote controller.
* Enter the address check/change mode and change the addresses.
If no number appears on UNIT No., no outdoor unit exists on the line. Push
following step
(Execute it while the units are stopped.)
1
Push and hold the TIME
At first, the line 1 and CODE No.
2
UNIT LOUVER
Push
Downloaded from www.Manualslib.com
/ buttons repeatedly to change the value indicated in the SET DATA section
button.
UNIT LOUVER
button (left side of the button) repeatedly to select another indoor UNIT No. to
4 6
to to change the indoor unit addresses so as to make each of them unique.
UNIT LOUVER
button (left side of the button) to check the changed addresses.
1
3
2
.
/ buttons at the same time for more than 4 seconds.
(left side of the button) and
manuals search engine
button to finish the procedure.
CODE No.
SET DATA SETTING
UNIT No.
R.C. No.
TEMP.
ON / OFF
TIMER SET
TIME
FILTER
RESET TEST SET CL
Cancels the line selection
(Address Change) are indicated on the LCD display.
SWING/FIX
buttons repeatedly to select a system address.
134
2
button and select another line