Important Notices - CipherLab 9200 Reference Manual

IMPORTANT NOTICES

FOR USA
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause
This equipment has been tested and found to comply with the limits for a Class B digital
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
operation.
reasonable protection against harmful interference in a residential installation. This
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
equipment generates, uses and can radiate radio frequency energy and, if not installed
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
and used in accordance with the instructions, may cause harmful interference to radio
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
communication. However, there is no guarantee that interference will not occur in a
harmful interference to radio communications.
particular installation. If this equipment does cause harmful interference to radio or
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
Reorient or relocate the receiving antenna.
- Connect the equipment into an outlet on a circuit different from that
Increase the separation between the equipment and receiver.
to which the receiver is connected.
Connect the equipment into an outlet on a circuit different from that to which the
- Consult the dealer or an experienced radio/TV technician for help.
receiver is connected.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's
Consult the dealer or an experienced radio/TV technician for help.
authority to operate this equipment.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
Operations in the 5.15-5.25GHz band are restricted to indoor usage only.
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
FOR CANADA
This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the following two conditions: (1) This device may not
This digital apparatus does not exceed the Class B limits for radio noise emissions from
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
digital apparatus as set out in the interference-causing equipment standard entitled
Ce dispositif est conforme à la norme CNR-210 d'Industrie Canada applicable aux appareils radio exempts de licence. Son fonctionnement est
"Digital Apparatus," ICES-003 of Industry Canada.
sujet aux deux conditions suivantes: (1) le dispositif ne doit pas produire de brouillage préjudiciable, et (2) ce dispositif doit accepter tout
brouillage reçu, y compris un brouillage susceptible de provoquer un fonctionnement indésirable. This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
Caution :
must accept any interference received, including interference that may cause undesired
(i) the device for operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel
operation.
mobile satellite systems;
(ii) the maximum antenna gain permitted for devices in the bands 5250-5350 MHz and 5470-5725 MHz shall comply with the e.i.r.p. limit; and
Cet appareil numerique respecte les limites de bruits radioelectriques applicables aux
(iii) the maximum antenna gain permitted for devices in the band 5725-5825 MHz shall comply with the e.i.r.p. limits specified for point-to-point
appareils numeriques de Classe B prescrites dans la norme sur le material brouilleur:
and non point-to-point operation as appropriate.
"Appareils Numeriques," NMB-003 edictee par l'Industrie.
(iv) Users should also be advised that high-power radars are allocated as primary users (i.e. priority users) of the bands 5250-5350 MHz and
5650-5850 MHz and that these radars could cause interference and/or damage to LE-LAN devices.
Avertissement:
Le guide d'utilisation des dispositifs pour réseaux locaux doit inclure des instructions précises sur les restrictions susmentionnées, notamment :
(i) les dispositifs fonctionnant dans la bande 5 150-5 250 MHz sont réservés uniquement pour une utilisation à l'intérieur afin de réduire les
risques de brouillage préjudiciable aux systèmes de satellites mobiles utilisant les mêmes canaux;
(ii) le gain maximal d'antenne permis pour les dispositifs utilisant les bandes 5 250-5 350 MHz et 5 470-5 725 MHz doit se conformer à la limite
de p.i.r.e.;
(iii) le gain maximal d'antenne permis (pour les dispositifs utilisant la bande 5 725-5 825 MHz) doit se conformer à la limite de p.i.r.e. spécifiée
pour l'exploitation point à point et non point à point, selon le cas.
(iv) De plus, les utilisateurs devraient aussi être avisés que les utilisateurs de radars de haute puissance sont désignés utilisateurs principaux (c.-à-
d., qu'ils ont la priorité) pour les bandes 5 250-5 350 MHz et 5 650-5 850 MHz et que ces radars pourraient causer du brouillage et/ou des
dommages aux dispositifs LAN-EL.
However, there is no guarantee that interference will not occur in a particular