Download Print this page
GRAUPNER X-8N User Manual
Hide thumbs Also See for X-8N:

Advertisement

Quick Links

Box Contents
1.
X-8N HoTT Radio
2.
GR-8 Receiver
3.
Temperature/Voltage Sensor (S8362)
4.
NiMH 2000mmA 4CELL
5.
SD-CARD
6.
USB Cable
7.
USB Gender
8.
Trim Switch (Trim 4.5 PS2) Box
9.
Manual
10. Warranty Card
Safety Warning Notes
• Never operate your car or truck in a crowded street with traffic. Especially, do not drive in a place near railway, chemical
substance, gas to prevent any damage.
• This product is not intended for use by inexperienced or disabled person without direct supervision of a responsible,
knowledgeable adult. This is not suitable for children under 18 years.
• This warranty does cover damaged products arising as a result of production process. It is not allowed to use to those
who are the disabled or do not have enough knowledge.
• The radio system is affected by signal environment and the electronic jamming signals can cause disorientation and loss
of control of your aircraft.
• Please read the manual to make the best use of the product
• Make sure to check all operations of channels before use.
• For the safe use, please operate the Range Check Mode before use.
• Be careful not to turn your transmitter off while in use.
• Do not touch or grab antenna during the use.
• Do not operate your model in the rain or run through standing water
• Fail Safe should be set before use to prevent uncontrollable situation occurred by any interruption.
It is recommended to set throttle channel to Neutral condition or brake condition.
• Always operate your program setup mode after stopping motor's power or engine and disconnecting drive battery.
• Make sure whenever you start operating your transmitter Please turn on your transmitter and then switch on your
receiver. Whenever you stop your transmitter, turn your receiver off before your transmitter is switched off.
• Always use new battery pack or charge your battery fully to avoid possible hazard causing by low battery capacity.
• Always be sure to check your battery capacity for your transmitter and receiver.
• As for boat model, we recommend installing your antenna vertically to the exterior boat and operating Range Check
Mode for the best use of your model.
X-8N Manual

Advertisement

loading

Summary of Contents for GRAUPNER X-8N

  • Page 1 X-8N Manual Box Contents X-8N HoTT Radio GR-8 Receiver Temperature/Voltage Sensor (S8362) NiMH 2000mmA 4CELL SD-CARD USB Cable USB Gender Trim Switch (Trim 4.5 PS2) Box Manual 10. Warranty Card Safety Warning Notes • Never operate your car or truck in a crowded street with traffic. Especially, do not drive in a place near railway, chemical substance, gas to prevent any damage.
  • Page 2: Specification

    The use of up to 35 hopping channels provides advanced reliable operation while keeping from any external interference. 2. Designed for beginners, X-8N HoTT Transmitter is the best choice for those who enjoy car, boat, and tank models. When optional Graupner Telemetry sensor or temperature sensor is used, you may check the real-time information such as model voltage, temperature, user programmable warnings.
  • Page 3: Operation

    Operation Battery Connection • Only use optional NiCd /NiMH 1.2volt, AA size rechargeable battery and Li-Po battery. • Remove the cover and install your battery to battery socket. Then, replace the cover making sure it is closed securely. • When low voltage warning alarm is activated, please use new battery or recharge the used battery. Please make sure the correct polarity when installing your battery.
  • Page 4 Menu 1. Main Screen ① Current Model No. and Name ② Dual Rate, ATL, 3CH, 4CH ③ Steering Trim ④ Throttle Trim ⑤ Radio Voltage and use time of Battery ⑥ TX, RX RF Antenna ⑦ Earphone Jack, SD card icon ⑧...
  • Page 5 : m a i n m e n u , m o v e t o m a i n p a g e : e s c a p e k e y : enter key : m e n u m o v i n g a n d s e t t i n g (DEC+INC+ENT) : m e n u k e y h o l d (Push 2sec) (FUN + ESC) : S c r e e n f o r S e r v o...
  • Page 6 3. Main Menu There are 4 pages and they could be moved by FUN switch. : Next Page : Menu select : move 1) MOD. SEL : model memory 2) MOD NAME : model name change 3) MOD COPY : m o d e l m e m o r y c o p y 4) MOD RES : m o d e l m e m o r y d e l e t e / r e s e t 5) RF SET : RF b i n d i n g / r a n g e t e s t 6) REVERSE : s e r v o r e v e r s e...
  • Page 7: Fcc Information

    For more information about where you can drop off your waste equipment for recycling, please contact your local city office, your household waste disposal service or where you purchased the produce Conformite Europeenne Product(s): Graupner X-8N Transmitter, Item Number(s): No. S1018 , No 33504 EN 62479:2010 EN 60950-1:2006/A11:2009/A1:2010/A12:2011 EN 301 489-1 V1.9.2...
  • Page 8 NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

This manual is also suitable for:

Gr-8