Telemetry Display - GRAUPNER X-8N Manual

Telemetry display

In order to display the telemetry data, press the INC or DEC button from the main screen. Then,
all available telemetry screens are displayed (only with bound receiver), depending on the
connected sensors or devices. The selection of the device or sensor is then set by pressing the
INC or DEC buttons. Then, confirm with ENTER.
Hidden mode
with the files to be selected. Press ENTER, the update starts. (see Chapter Firmware update)
38
INC
DEC
The number of the connected devices
INC
is displayed in the upper right corner.
Depending on the selection of the device,
different screens appear.
(Please also read the instructions of the
device or sensor)
DEC
You can enter HIDDEN MODE from the main screen, by
pressing the UP and DOWN buttons simultaneously. Here,
you can load the voice files or a firmware update from the
SC card. You can also do the stick calibration.
VOICE: Press ENTER, if you have inserted an SD card with
the corresponding voice files, a list appears with the files to
be selected. Press ENTER, the update starts.
FIRMWARE UPDATE: Press ENTER, if you have inserted an
SD card with the corresponding update files, a list appears
STICK CALI.: If the full deflections of the encoders cannot
be reached anymore, this menu is used to perform the stick
calibration. Turn the steering wheel or press the throttle lever
into the indicated direction up to the stop and press ENTER.
Then into neutral position, press ENTER. Now, into the other
direction up to the stop, press ENTER.